[mems-talk] Dicing saw

[R.Loiacono at surrey.ac.uk]

Following this post, I have the same problem. I have been looking on the
internet for a long time, but basically dicing saws (for silicon, in my
case) are really bulky, big and expensive. It would be nice to have a
dicing saw that can just be put on a table for cutting wafers or dicing
smaller samples.

Any suggestions?

Thank you.

Renzo

-----Original Message-----
From: mems-talk-bounces at memsnet.org
[mailto:mems-talk-bounces at memsnet.org] On Behalf Of Haixin Zhu
Sent: 06 February 2008 15:43
To: General MEMS discussion
Subject: [mems-talk] Dicing saw

Dear all,

We are looking for affordable 4 inch dicing saw for glass wafer cutting,
automation not required, table-top, precise alignment.

Any one has a suggestion where I can get it?

Thanks

Michael