Anodic bonding of Pyrex to nitride has been reported by several sources.  In
general, the conditions will be similar to that for silicon to glass.  However,
key factors are that a higher initial voltage may be required, and the surface
preparation of the nitride is important

Best Regards,

Chad Brubaker

EV Group       invent * innovate * implement
Technology - Tel: (602) 437-9492, Fax: (602)437-9435 e-mail:
C.Brubaker@EVGroup.com, www.EVGroup.com

This message and any attachments contain confidential or privileged information,
which is intended for the named addressee(s) only. If you have received it in
error, please notify the sender immediately and then delete this e-mail. Please
note that unauthorized review, copying, disclosing, distributing or otherwise
making use of the information is strictly prohibited.

 -----Original Message-----
From:   mems-talk-bounces@memsnet.org [mailto:mems-talk-bounces@memsnet.org]  On
Behalf Of Rahul Agarwal
Sent:   Thursday, June 24, 2004 8:31 PM
To:     mems-talk@memsnet.org
Subject:        [mems-talk] anodic bonding with nitride on silicon wafer

Hello everyone,
I wanted to know if any of you has any experience in doing anodic bonding
of
a n-type wafer with 1000A thick nitride (LPCVD), to a pyrex glass
wafer. All the suggestions will be highly appreciated.
Thanks
Rahul agarwal