You might also try Micrion Corporation.  Email to
micrionadmin@compuserve.com .
Good luck.  Bob


-----Original Message-----
From: Ami Chand 
To: MEMS@ISI.EDU 
Date: Wednesday, October 07, 1998 11:57 AM
Subject: Re: Fw: Can you drill a 3 nanometer diameter hole?


>Gordon,
>
>You may try focussed ion beam. I undersand it is possible to drill a hole
>down to 5nm using FIB. You may contact FIB International (408)  567-8068
>and their web site is: www.fibinternational.com
>
>ami chand
>
>
>Ami Chand, Physics Department, University of California, Santa Barbara
>CA 93106, USA,  Tel : 805 - 893 - 3999 ( Lab ), 805 - 893 - 8089 ( Off),
>Fax: 805 - 893 - 8315.
>
>
>On Wed, 2 Sep 1998, unifieduniverse wrote:
>
>>
>>
>> ----------
>> > From: unifieduniverse 
>> > To: sinitsyn@ire.saratov.su
>> > Subject: Can you drill a 3 nanometer diameter hole?
>> > Date: Monday, August 31, 1998 3:29 PM
>> >
>> > Dear N. I. Sinitsyn:
>> >
>> > We are trying to fabricate a device.  We need to be able to drill 3 or
4
>> > nanometer diameter holes in 5 or 5.1 nanometer thick carbon films or
>> > formvar or iridium foil.  None of our electron microscope contacts can
do
>> > this.  Presumably it needs a coherent electron microscope through
>> coherent
>> > field emission tip, or coherent electron microscope through nanotube
>> > electron source.  We are willing to pay for this service with American
>> > dollars.  Can you do it?  What do you bid for one hole in one film?
For
>> > one hole each in 40 films?
>> >
>> > Respond as soon as you can.  Or refer us to someone else you think
might
>> be
>> > able to do this.
>> >
>> > Thanks.
>> >
>> > Sincerely yours,
>> >
>> > Gordon Ziegler, President
>> > Coherent Electron Source, LLC
>> > 4401 37th Ave SE #17
>> > Lacey, WA 98503, USA
>> >
>> > phone (360) 459-3209
>> >
>> > fax (360) 459-3705
>> >
>> > e-mail  unifieduniverse@olywa.net
>>
>>
>
>