Hi all,

I am working on a new process and require to release my polyimide film
fabrication. The release in hot water has been a bit problematic. I was
wondering if anyone has used Omnicoat. The Tg is around 190C but just wondering
if it will be stabile up to 300C which is what the Polyimide needs to cure.

I could find any data or info online about this.

Cheers,
Darren
_______________________________________________
Hosted by the MEMS and Nanotechnology Exchange, the country's leading
provider of MEMS and Nanotechnology design and fabrication services.
Visit us at http://www.mems-exchange.org

Want to advertise to this community?  See http://www.memsnet.org

To unsubscribe:
http://mail.mems-exchange.org/mailman/listinfo/mems-talk