Robert: I have deposited stainless by sputtering. You will not be able to buy a target, just get your machine shop to make you one. Sincerely Michele Migliuolo Verimetra, Inc. >> >Hello, >> Does anyone know if it is possible to deposit a thin layer of stainless >> steel (any of the stainless steel alloys) by sputtering or E-beam >> deposition? I have not been able to locate a target for either >> process. Stainless steel has some interesting adhesion properties I would >> >> like to exploit in MEMS applications. >> Sincerely, >> Robert Dean >> Research Associate IV >> Center for Advanced Vehicle Electronics >> Auburn University >> 200 Broun Hall >> Auburn, AL 36849 >> Voice: 334-844-1838 >> Fax: 334-844-1898 >> Email: rdean@eng.auburn.edu >> Web: http://www.eng.auburn.edu/~rdean >> _______________________________________________ >> MEMS-talk@memsnet.org mailing list: to unsubscribe or change your list >> options, visit http://www.memsnet.org/mailman/listinfo/mems-talk >> Hosted by the MEMS Exchange, providers of MEMS processing services. >> Visit us at http://www.memsnet.org/