I use kapton tape to glue my moulds to a PMMA structure before pouring PDMS.
Usually the PDMS ends up covering the kapton and I'm able to easily peel it off
after curing, so I'm guessing it is not a very good option for bonding.

- João Tiago S. Fernandes
________________________________
From: Gianmario Scotti
Sent: ‎15/‎07/‎2014 17:34
To: General MEMS discussion
Subject: [mems-talk] What glue for Kapton?

Dear all,


I am may need to glue a thin sheet of Kapton onto one of my chips.  I am
thinking about PDMS, but am unsure how well it bonds to Kapton. Did anyone
try this?



mario

--
Gianmario Scotti

Researcher
Aalto University, Dept. of Materials Science and Engineering
http://materials.aalto.fi/en/

Micronova, Tietotie 3
02150 Espoo
Finland
_______________________________________________
Hosted by the MEMS and Nanotechnology Exchange, the country's leading
provider of MEMS and Nanotechnology design and fabrication services.
Visit us at http://www.mems-exchange.org

Want to advertise to this community?  See http://www.memsnet.org

To unsubscribe:
http://mail.mems-exchange.org/mailman/listinfo/mems-talk
_______________________________________________
Hosted by the MEMS and Nanotechnology Exchange, the country's leading
provider of MEMS and Nanotechnology design and fabrication services.
Visit us at http://www.mems-exchange.org

Want to advertise to this community?  See http://www.memsnet.org

To unsubscribe:
http://mail.mems-exchange.org/mailman/listinfo/mems-talk