Thanks a lot, João. Good to know before I even try.


mario


On Tue, Jul 15, 2014 at 9:52 PM, João Tiago dos Santos Fernandes <
jfernandes@inesc-mn.pt> wrote:

> I use kapton tape to glue my moulds to a PMMA structure before pouring
> PDMS. Usually the PDMS ends up covering the kapton and I'm able to easily
> peel it off after curing, so I'm guessing it is not a very good option for
> bonding.
>
> - João Tiago S. Fernandes
> ________________________________
> From: Gianmario Scotti
> Sent: ‎15/‎07/‎2014 17:34
> To: General MEMS discussion
> Subject: [mems-talk] What glue for Kapton?
>
> Dear all,
>
>
> I am may need to glue a thin sheet of Kapton onto one of my chips.  I am
> thinking about PDMS, but am unsure how well it bonds to Kapton. Did anyone
> try this?
>
>
>
> mario
>
> --
> Gianmario Scotti
>
> Researcher
> Aalto University, Dept. of Materials Science and Engineering
> http://materials.aalto.fi/en/
>
> Micronova, Tietotie 3
> 02150 Espoo
> Finland
> _______________________________________________
> Hosted by the MEMS and Nanotechnology Exchange, the country's leading
> provider of MEMS and Nanotechnology design and fabrication services.
> Visit us at http://www.mems-exchange.org
>
> Want to advertise to this community?  See http://www.memsnet.org
>
> To unsubscribe:
> http://mail.mems-exchange.org/mailman/listinfo/mems-talk
> _______________________________________________
> Hosted by the MEMS and Nanotechnology Exchange, the country's leading
> provider of MEMS and Nanotechnology design and fabrication services.
> Visit us at http://www.mems-exchange.org
>
> Want to advertise to this community?  See http://www.memsnet.org
>
> To unsubscribe:
> http://mail.mems-exchange.org/mailman/listinfo/mems-talk
>



--
Gianmario Scotti

Researcher
Aalto University, Dept. of Materials Science and Engineering
http://materials.aalto.fi/en/

Micronova, Tietotie 3
02150 Espoo
Finland
_______________________________________________
Hosted by the MEMS and Nanotechnology Exchange, the country's leading
provider of MEMS and Nanotechnology design and fabrication services.
Visit us at http://www.mems-exchange.org

Want to advertise to this community?  See http://www.memsnet.org

To unsubscribe:
http://mail.mems-exchange.org/mailman/listinfo/mems-talk