Hello Moona, could you let me know rough dimension of your device? and also what kind of material do you want to use? cantilever itself and also carrying substrate? one more, If you look at top surface of cantilever, then there should be nothing on your sight except cantilever? for example you might wanna remove part of substrate for certain experiment scheme. Good luck Myung Rae. On Wed Oct 23 13:15:18 2013, girija moona wrote: > hello everyone, > it would be great if someone could help me microcantilever fabrication. i > need all the steps in detail... since in am very new to this field and want > to work in the area to microcantilever sensors. i will be very thankful if > i get some basic procedure for microcantilever fabrication. > thanks > > Regards > Girija Moona > _______________________________________________ > Hosted by the MEMS and Nanotechnology Exchange, the country's leading > provider of MEMS and Nanotechnology design and fabrication services. > Visit us at http://www.mems-exchange.org > > Want to advertise to this community? See http://www.memsnet.org > > To unsubscribe: > http://mail.mems-exchange.org/mailman/listinfo/mems-talk _______________________________________________ Hosted by the MEMS and Nanotechnology Exchange, the country's leading provider of MEMS and Nanotechnology design and fabrication services. Visit us at http://www.mems-exchange.org Want to advertise to this community? See http://www.memsnet.org To unsubscribe: http://mail.mems-exchange.org/mailman/listinfo/mems-talk