Brad, maybe the problem is de-wetting of the PR. Sure sounds like it. How about a short HMDS prime. Gary -----Original Message----- From: mems-talk-bounces@memsnet.org [mailto:mems-talk-bounces@memsnet.org]On Behalf Of Shah, Forum N Sent: Wednesday, July 22, 2009 8:29 PM To: Brad Cantos; General MEMS discussion Subject: Re: [mems-talk] SPR 220-7 Brad, The problem still persists even with a two step spinning. I do use the same recipe that you suggested. Streaks are radial in appearance as you mentioned. If two step recipe has worked for you, can you suggest what ramp rate should i be looking at? the recipe that i followed was: Step 1: Spin at 500 rpm with ramp rate of 100 rpm/s (lowest) for 10 sec. Step 2: Spin at 3000rpm /3500 rpm at ramp rate of 100 rpm/s for 30 sec. What soft bake do you prefer for this kind of recipe? Does it help get rid of streaks? If you have any other suggestions do let me know. Thanks in advance. I appreciate your help. Forum