durusmail: mems-talk: RIE Silicon etching
RIE Silicon etching
2014-07-25
2014-07-24
2014-07-25
2014-07-24
RIE Silicon etching
Andrew Sarangan
2014-07-24
If the film looks grey or black, then it is most likely carbon from CF4.


On Wed, Jul 23, 2014 at 11:00 AM, Sebastian R Freeman
 wrote:
> Hi everyone,
>
> I am etching a 4-inch silicon wafer in the RIE using O2, and CF4, in
> combination. Using positive photoresist, my goal is to create an array of
> silicon pillars covering the surface of the wafer. I am trying to push the
> limits of the machine, and trying to etch several microns. I etched for 5
> minutes and was able to get 1.5 micron tall pillars, the wafer came out of
> the machine very dirty, with a film-like residue on it, and looking very
> scratched up. I think I might have an idea of what this is, but I would
> appreciate anyone else's input, or a way to prevent it.
>
> *Sebastian Freeman*
> *Ph.D Student*
>
> *Binghamton University *
>
> *Thomas J. Watson School of Engineering*
> *Department of Bioengineering*
> *Office: Biotechnology Building 2629*
> *E-mail: sfreema1@binghamton.edu *
> _______________________________________________
> Hosted by the MEMS and Nanotechnology Exchange, the country's leading
> provider of MEMS and Nanotechnology design and fabrication services.
> Visit us at http://www.mems-exchange.org
>
> Want to advertise to this community?  See http://www.memsnet.org
>
> To unsubscribe:
> http://mail.mems-exchange.org/mailman/listinfo/mems-talk
_______________________________________________
Hosted by the MEMS and Nanotechnology Exchange, the country's leading
provider of MEMS and Nanotechnology design and fabrication services.
Visit us at http://www.mems-exchange.org

Want to advertise to this community?  See http://www.memsnet.org

To unsubscribe:
http://mail.mems-exchange.org/mailman/listinfo/mems-talk
reply